ISO INTERNATIONAL STANDARD 5240 Second edition 1994-12-01 Textile machinery and accessories Warp creels Main dimensions Materiel pour I'industrie textile-Cantres d'ourdissage-Dimensions principales OSI Reference number ISO 5240:1994(E) or Standardiza Licensee=NASA Technical Standards 1/9972545001 No reproduction or networking permited without license from IHS ISO5240:1994(E) Foreword Iso (the International Organization for Standardization) is a worldwide of preparing International Standards is normally carried out through IsO technical committees. Each memberbody interested in a subject for whicha technical committee has been established has the right to be represented on that committee.International organizations,governmental and non-governmental, in liaison with Iso, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnicai standardization. circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. InternationalStandardISO5240waspreparedbyTechnicalCommittee committee SC 2,Winding and preparatory machinery for fabric manufac- ture. This second edition cancels and replaces the first edition (is0 5240:1978), of which table 1 has been technically revised. ISO1994 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced microfilm, without permission in writing from the publisher. International Organizationfor Standardization Case Postale 56· CH-1211 Geneve 20· Switzerland Printed in Switzerland No reproduction or networking permited without license from IHS Not for Resale, 04/26/2007 02:17:32 MDT INTERNATIONALSTANDARDISO ISO5240:1994(E) Textile machinery and accessories - Warp creels - Main dimensions 1 Scope applied in the vertical direction, and twice-indicated values in the horizontal. 2 Terminology This International Standard establishes terminology for warp creels and specifies their main dimensions. See figure 1. The pitches P should be applied for simple warp 3 Dimensions creels and only for packages unwound overend. For magazine warp creels, the same pitches should be Seefigure1andtable1. 1 Copyright inteinatioal Organizatin for Standardizatin No reproduction or networking permitted without license from IHS ards1/9972545001