ISO INTERNATIONAL STANDARD 11547 First edition 1994-10-01 Small craft Start-in-gear protection Navires de plaisance -Dispositif de protection contre le demarrage avec vitesseenprise ISo Reference number ISO 11547:1994(E) ISO11547:1994(E) Foreword IsO (the International Organization for Standardization) is a worldwide of preparing International Standards is normally carried out through isO technical committees. Each member body interested in a subject for representedon that committee.International organizations,governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC)onall matters of electrotechnical standardization. Draft International Standards adopted by thetechnical committees are a vote. International Standard iSO 11547 was prepared by Technical Committee ISO/TC188,Small craft. ISO 1994 microfilm, without permission in writing from the publisher International Organization for Standardization Case Postale 56. CH-1211 Geneve 20·Switzerland Printed in Switzerland = INTERNATIONAL STANDARD ISO IS0 11547:1994(E) Smaii craft Start-in-gear protection 1 Scope 3.3 remote starting: Engine starting controi mech- anism iocated at a position rermote from the outboard This internationai Standard specifies requirements to motor. prevent an outboard motor from being started in gear. when instalied on srnali craft of up to 24 m iength of 3.4 local starting: Starting control mechanism lo- huli. cated at or on the outboard motor. 2 Normative references 4 Requirements Tne foiiowing standardis contain provisions which. 4.1 Every outboard motor capabie of deveioping a through reference in this text. constitute provisions static thrust (boiard puii) according to isO 13342 of of this internationai Standard.At the time of pubi- 50o N or more with any propelier or jet attachment cation, the editions indicated were valid. All standards availabie for that motor from the manufacturer shaii are subject to revision, and parties to agreements based on this internationai Standard are encouraged be equipped with a device to prevent the motor from being started in gear when the controls are set so as to investigate the possibility of applying the most re- to attain or exceed a thrust of 500 N. cent editions of thestandardsindicated beiow. Members of EC and ISO maintain registers of cur- rently valid Internationa! Standards. 4.2 Motors equipped with remote starting systems may have either an integral start-in-gear protection Iso 11192:—1, Small craft Graphica! symbols. device as required in 4.1, or a similar device incorpor- ated in the remote control system. In the latter case, iso13342:—1),Smali craft—Static thrust measure- a iabei shaii be affixed to the motor close to the con- ment for outboard motors. troi connection With the WARNiNG and the READ OWNER'S MANUAL symbois in accordance with 3Definitions isO 11192 (see figure 1). For the purposes of this international Standard, the following definitions appiy. 3.1 static thrust: Forward or astern thrust devel- oped by an outboard motor while stationary. 3.2 remote control: Engine throttle, shift and start- Figure 1 ing contro! mechanism located at a position remote from the outboard motor. 1)Tobepubished.