ISO INTERNATIONAL STANDARD 14527-1 First edition 1999-11-15 Plastics Urea-formaldehyde and urea/melamine-formaldehyde powder moulding compounds (UF- and UF/MF-PMCs)- Part 1: Designation system and basis for specifications Plastiques - Poudres a mouler a base d'urée-formaldéhyde et d'urée/meélamine-formaldéhyde (UF- et UF/MF-PMC) - Partie 1: Systeme de désignation et base de spécification Reference number ISO 14527-1:1999(E) ISO @ ISO 1999 HS under Not for Resale ISO14527-1:1999(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is a trademarkof Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event @ISO1999 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland @ISO1999-All rights reserved ermittedwithoutlicense from IHS Not for Resale ISO 14527-1:1999(E) Foreword ISsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this part of isO 14527 may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. International Standard ISO 14527-1 was prepared by Technical Committee ISO/TC 61, Plastics, Subcommittee SC 12, Thermosetting materials. three parts of ISO 14528, will replace ISO 2112:1990, of which they constitute a technical revision urea/melamine-formaldehyde powder moulding compounds (UF- and UF/MF-PMCs): Part 1:Designation systemand basis for specifications Part 2: Preparation of test specimens and determination of properties Part 3: Requirements for selected moulding compounds ii
ISO 14527-1 1999 Plastics — Urea-formaldehyde and urea melamine-formaldehyde powder moulding compounds (UF- and UF
文档预览
中文文档
12 页
50 下载
1000 浏览
0 评论
309 收藏
3.0分
温馨提示:本文档共12页,可预览 3 页,如浏览全部内容或当前文档出现乱码,可开通会员下载原始文档
本文档由 人生无常 于 2024-09-28 09:51:51上传分享