ISO INTERNATIONAL STANDARD 9563 Secondedition 2015-09-01 Belt drives Electrical conductivity of antistatic endless synchronous belts Characteristics and test method Transmissions parcourroies-Conductibiliteélectriquedes courroies synchrones sans fin,anti-électrostatiquesSpécification etméthoded'essai Reference number ISO9563:2015(E) ISO Intermational Organization for Standardization @IS02015 dardization5956617 itted without license from IHS IS09563:2015(E) COPYRIGHTPROTECTEDDOCUMENT IS02015,Published inSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8. CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +4122 749 09 47 [email protected] www.iso.org Intemationaibr PrganizationforStandardization etworking permitted without license from IHS Notfor Resale, 2015/11/11 08:45:29 IS09563:2015(E) Contents Page Foreword ..iv 1 Scope. 2 Normative references 3 Electrical resistancespecification 3.1 General .1 3.2 Resistancevalue. .2 3.3 Minimumvalueofelectrical resistance. .2 4 Selection and preparation ofbelts fortest. .2 4.1 Laboratory test. .2 4.2 Production test .2 5 Testmethod .3 5.1 Apparatus- insulationtester .3 5.2 Electrodesand contactsforlaboratoryand productiontests 3 5.3 Test procedures .3 5.3.1 Laboratory test .3 5.3.2 Production test 3 5.3.3 Test timing. .3 5.3.4 Interpretationofresults .3 Annex A (informative) Electrical conductive coating .5 Bibliography .6 Intematinal oganzation @st(S.20.1.5 - All rights reserved iii ithout license from IHS