ISO INTERNATIONAL STANDARD 11064-4 Second edition 2013-11-15 Ergonomic design of control centres Part 4: Layout and dimensions of workstations Conception ergonomique des centres de commande - Partie 4: Agencement et dimensionnement du poste de travail Reference number IS0 11064-4:2013(E) LSO @ IS0 2013 ed without license from IHS Not for Resale IS0 11064-4:2013(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ IS0 2013 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 11064-4:2013(E) Contents Page Foreword ..iv Introduction. 1 Scope. ..1 2 Normative references 3 Terms and definitions 4 Initial control workstation layout considerations 5 Factors determining control workstation design .4 5.1 General user considerations. .5 5.2 Visual tasks. .9 5.3 Auditory tasks .10 5.4 Working postures .10 6 Control workstation layout .12 6.1 General layout considerations. ..13 6.2 Layout requirements ..14 7 Control workstation dimensions ..17 7.1 Dimension considerations ..17 7.2 Seated control workstations. ..17 7.3 Standing control workstations. ..18 Annex A (informative) Arranging displays and control workstations. ..19 Annex B (informative) Conformance matrix .30 Bibliography .37 iii ded by IHS under lic ense with ISt withoutlicense from IHS Not for Resale