© ISO 2016Road vehicles — Local Interconnect Network (LIN) — Part 6: Protocol conformance test specification Véhicules routiers — Réseau Internet local (LIN) — Partie 6: Spécification  du protocole  d’essai de conformitéINTERNATIONAL STANDARDISO 17987-6 First edition 2016-10-01 Reference number ISO 17987-6:2016(E) --``,,,`,```,,``,,,,```,``,,``,-`-`,,`,,`,`,,`--- ISO 17987-6:2016(E) ii © ISO 2016 – All rights reservedCOPYRIGHT PROTECTED DOCUMENT © ISO 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 • CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 copyright@iso.org www.iso.org --``,,,`,```,,``,,,,```,``,,``,-`-`,,`,,`,`,,`--- ISO 17987-6:2016(E) Foreword ...................................................................................................................................................................................................................................... vii Introduction ............................................................................................................................................................................................................................ viii 1 Scope ................................................................................................................................................................................................................................. 1 2 Normati ve references ...................................................................................................................................................................................... 1 3 Terms, definitions, symbols and abbreviated terms ....................................................................................................... 1 3.1 T erms and definitions ....................................................................................................................................................................... 1 3.2 S ymbols ......................................................................................................................................................................................................... 2 3.3 A bbreviated terms ............................................................................................................................................................................... 3 4 Conventions ............................................................................................................................................................................................................... 4 5 General test specification considerations .................................................................................................................................. 4 5.1 Gener al ........................................................................................................................................................................................................... 4 5.2 T est conditions ........................................................................................................................................................................................ 4 5.3 Mandat ory requirements for IUT as master .................................................................................................................. 4 5.4 Mandat ory requirements for IUT as slave ....................................................................................................................