8736 International Standard (ISO INTERNATIONAL ORGANIZATION FOR STANDARDIZATION+MEKAYHAPOAHAR OPrAHW3ALMA HO CTAHAAPTW3AUWM+ORGANISATION INTERNATIONALE DE NORMALISATION Taper pins with internal thread, unhardened Goupilles de position coniquesatroutaraude,non trempées Firstedition-1986-11-01 ISO 8736-1986 (E) UDC 621.886.115 Ref. No. ISO 8736-1986 (E) Descriptors : fasteners, pins (mechanics), taper pins, specifications, dimensions, designation. Price based on 3 pages Not for Resale Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technicai committees.Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with Iso, also take part in the work. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the iso Council. They are approved in accordance with ISO procedures requiring at least 75 % approval by the member bodies voting. International Standard ISO8736 was prepared byTechnical Committee ISO/TC 2, Fasteners. Users should note that all International Standards undergo revision from time to time and that any reference made herein to any other International Standard implies its latestedition,unlessotherwisestated InternationalOrganizationforStandardization,1986 Printed inSwitzerland Copyright International Organization for Standardization No reproduction or networking permitted without license from IHS Not for Resale ISO 8736-1986 (E) INTERNATIONAL STANDARD Taper pins with internal thread, unhardened Scope and field of application This International Standard specifies the characteristics of unhardened taper pins with internal thread, and metric dimensions and nominal diameters, di, from 6 to 50 mm inclusive. 2 References iso965,/sogeneralpurposemetricscrewthreads---Tolerances. Iso2081,Metallic coatings--Electroplated coatings of zinc on ironor steel. Iso 3269, Fasteners - Acceptance inspection. Iso4520, Chromate conversion coatings on electroplated zinc and cadmium coatings. 7 Copyright International Organization for Standardization license with ISC No reproduction or networking permitted without license from IHS Not for Resale