ISO INTERNATIONAL STANDARD 7876-3 NORME First edition Premiere édition 1993-07-15 INTERNATIONALE Fuel injection equipment -- Vocabulary - Part 3: Unit injectors Equipement d'injection de combustible - Vocabulaire- Partie 3: Injecteurs-pompes Reference number Numero de reference ISO 7876-3:1993(E/F) ISO7876-3:1993(E/F) Contents 1 Scope 2 Normative references ... 3 Main definition. 2 4 Components.. 2 5 Generalterms. 3 Annex A: Bibliography... 4 Alphabetical indexes English 5 French...... 6 Sommaire 1 Domaine d'application 2 References normatives 3 Definition principale ... 2 4Composants. 2 5 Termes generaux.. 3 Annexe A:Bibliographie. Index alphabetiques Anglais. 5 Francais 6 CISO1993 Ali rights reserved. No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher./Droits de reproduction reserves. Aucune partie de cette publication ne peut étre reproduite ni utilisee sous quelque forme que ce soit et par aucun procede,électronique oumécanique,y compris la photocopie et les microfilms,sans I'accord ecrit de I'éditeur. InternationalOrganizationforStandardization Case postale 56·CH-1211Geneve 20·Switzerland Printed in Switzerland/lmprimé en Suisse ii IS07876-3:1993(E/F) Foreword ISo (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing Inter- national Standards is normally carried out through Iso technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with Iso, also take part in the work. Iso collaborates closely with the International Electro- technical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an international Standard requires approval by at least 75% of the member bodies casting a vote. International Standard ISO 7876-3 was prepared by Technical Committee ISO/Tc 22, Road vehicles, Sub-Committee Sc 7, Injection equipment and filters for use on road vehicles. IsO 7876 consists of the following parts, under the general title Fuel injection equipment -- Vocabulary : 一 Part1:Fuel injection pumps —Part2:Fuel injectors Part3:Unitinjectors -Part4:High-pressurepipesandend connections Annex A of this part of Iso 7876 is for information only. ili