4851903 0643963 534 INTERNATIONAL ISO STANDARD 8489-5 First edition 1995-12-15 Textile machinery and accessories Cones for cross winding Part 5: Dimensions, tolerances and designation of cones with half angle 5°57 MatérielpourI'industrietextileConespourbobinagecroisé- Partie 5: Dimensions, tolérances etdésignation des cones avec demi-angleausommetde5°57' so Reference number ISO 8489-5:1995(E) CoPYRIGHT 2ooo International OrganizationFor Standardization Information Handling Services, 2ooo 4851903 0643964 470 ISO 8489-5:1995(E) Foreword iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (Iso member bodies). The work of preparing International Standards is normally carried out through IsO technicalcommittees. Each member body interested in a subject for represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (lEC)onallmattersofelectrotechnical standardization. circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard iSO 8489-5 was prepared by Technical Committee isO/Tc 72, Textile machinery and allied machinery and accessories, Sub- committee sc 2, Winding and preparatory machinery for fabric manufac- ture. This first edition of ISO 8489-5 cancels and replaces ISO 5237:1978. which has been technically revised. IsO 8489 consists of the following parts, under the general title Textile machineryandaccessories Conesforcrosswinding: Part1:Recommendedmain dimensions 一 Part 2: Dimensions, tolerances and designation of cones with half angle 3 degrees 30 Part 3: Dimensions, tolerances and designation of cones with half angle 4 degrees 20° Part 4: Dimensions, tolerances and designation of cones with half angle 4 degrees 20' for winding for dyeing purposes - Part 5: Dimensions, tolerances and designation of cones with half angle 5 degrees 57 ISO 1995 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Organization for Standardization Case Postale56:CH-1211Geneve20·Switzerland Printed in Switzerland ii CoPYRIGHT 2ooo International OrganizationFor Standardization Information Handling Services, 2oo0 596E90 E06T59h 307 INTERNATIONALSTANDARD ISO ISO 8489-5:1995(E) Textile machinery and accessories Cones for cross winding - Part 5: Dimensions, tolerances and designation of cones with half angle 5° 57' Scope This part of Iso 8489 specifies the main dimensions, tolerances and designation of cones for cross winding with a half angle of cone 5° 57'. Furthermore, directives are given for the characteristics of cones and for the control of the diameters and lengths of the cone. 2 Normative references The following standards contain provisions which, through reference in this text, constitute provisions of this part of Is0 8489. At the time of publication, the editions indicated were valid. All standards are subject to revision, and most recent editions of the standards indicated below. Members of IEc and Iso maintain registers of currently valid InternationalStandards. ISO 286-1:1988, ISO system of limits and fits - Part 1: Bases of tolerances, deviations and fits. dimensions. InformationHandlingServices,2ooo