ISO INTERNATIONAL STANDARD 8092-1 Second edition 1996-02-01 Road vehicles - Connections for on-board electrical wiring harnesses : Part 1: Tabs for single-pole connections Dimensions and specific reguirements Vehicules routiers - Connexions pour faisceaux de cablage électrique embarques Partie 1: Languettes pour raccordements unipolaires Dimensions et exigencesparticulieres ISO Referencenumber ISO 8092-1:1996(E) Copyright International Organization for Standardizatior d without license from IHS lot for Resale ISO 8092-1:1996(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through isO which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International a vote. international Standard ISO 8092-1 was prepared by Technical Committee ISO/TC 22.Road vehicles, Subcommittee SC 3,Electrical and electronic equipment. This second edition cancels and replaces thefirst edition (iS0 8092-1:1989), of which it constitutes a technical revision. ISO 8092 consists of the following parts, under the general title Road ve- Connections for on-board electrical wiring harnesses: Part 1: Tabs for single-pole connections - Dimensions and specific requirements Part 2: Definitions, test methods and general performance require- ments Part 3: Tabs for multi-pole connections -- Dimensions and specific reguirements Part 4: Pins for single- and multi-pole connections - Dimensions andspecificrequirements Annex A of this part of ISO 8092 is for information only. ISO1996 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced microfilm, without permission in writing from the publisher. InternationalOrganizationforStandardization Case Postale 56.CH-1211Geneve20·Switzerland Printed in Switzeriand Not for Resale ISO 8092-1:1996(E) INTERNATIONAL STANDARD ISO Road vehicles -- Connections for on-board electrical wiring harnesses Part 1: Tabs for single-pole connections Dimensions and specific requirements 1 Scope 4 Dimensions This part of IsO 8092 specifies dimensions for the Tabs for single-pole connections shall conform to the tabs of single-pole connections and specific require- dimensions given in table 1 and figure 1. ments, for on-board electrical wiring harnesses of road vehicles, which can be fitted into female con- Details not specified are left to the manufacturer's tacts such as those given in annex A. It applies to choice. connectors designed to be disconnected after mounting in the vehicle for the purposes of repair and/ormaintenance only. 5 Specific performance requirements 2 Normative reference Single-pole connections shall be in conformity with the general performance requirements of IS0 8092-2, The following standard contains provisions which, and shall meet the following specific requirements. through reference in this text, constitute provisions of this part of ISO 8092. At the time of publication, the edition indicated was valid. All standards are subject to revision, and parties to agreements based on this 5.1 Design requirements part of s0 8092 are encouraged to investigate the possibility of applying the most recent edition of the A tab without detent requires external means of re- standard indicated below. Members of IEC and ISO tention to the mating part. If tabs are stamped or maintain registers of currently valid International stamped and formed, the usable contact area shall be specified and care shall be taken to assure