ISO INTERNATIONAL STANDARD 5845-2 First edition 1995-11-01 Technical drawings - Simplified representation of the assembly of parts with fasteners -- Part 2: Rivets for aerospace equipment au moyen d'élements defixation Partie2:Rivets pour constructions aérospatiales (so Reference number ISO 5845-2:1995(E) Copyright International Organization for Standardization icense with IS networking permitted without license from IHS Not for Resale ISO 5845-2:1995(E) Foreword ISO (the International Organization for Standardization) is a worldwide of preparing International Standards is normally carried out through IsO technicai committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. international organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. ISO/TC 10, Technical drawings, product definition and related documen- tation, Subcommittee Sc 6, Mechanical engineering documentation. ISO 5845 consists of the following parts, under the general title Technical drawings Simplified representation of the assembly of parts with fasteners: - Part 1: General principles Part2:Rivets foraerospaceequipment ISO1995 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher International Organization for Standardization Case Postale 56 · CH-1211 Geneve 20· Switzerland Printed in Switzerland anzSandadiza d without license from IHS Not for Resale CISO ISO 5845-2:1995(E) Introduction Is0 5845 has been devised to provide a universal means of communi- cation among the various parties involved in the design and manufacture, in general, as well as the installation of fasteners. The representation of rivets on technical drawings should conform to one of the following two methods, which must meet requirements for micro- copying and reproduction: a conventional drawing of rivets (according to IsO 128): this method is particularly suitable for drawings containing a small number of rivets. b) symbolic representation; this method is best suited to drawings con- tainingalargenumberofrivets(see clause4). Requirements within industries vary considerably: in recognition of this fact, ISO 5845 is presented in two parts. Part 1 is mainly devoted to Both are recommended for application to other fields as well. ni Not for Resale