ISO INTERNATIONAL STANDARD 5347-13 First edition 1993-12-15 Methods for the calibration of vibration and shock pick-ups Part 13: Testing of base strain sensitivity Methodes pour I'étalonnage de capteurs de vibrations et de chocs- Partie 13: Essai de sensibilité de contrainte de base rso Reference number ISO 5347-13:1993(E) Copyright Intermational Organization for Standardization mitted without license from IHS Not for Resale ISO5347-13:1993(E) Foreword ISO (the International Organization for Standardization) js a worldwide federationofnationalstandardsbodies(lSOmemberbodies).Thework of preparing International Standards is normally carried out through IsO technical committees.Eachmemberbodyinterested in a subjectfor which a technical committee has been established has the right to be and non-governmental, in liaison with IsO, aiso take part in the work. isO collaborates closely with the International Electrotechnica! Commission (lEC)onallmattersofelectrotechnicalstandardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International a vote. International Standard ISO 5347-13 was prepared by Technical Committee and calibration of vibration and shock measuring instruments. IsO 5347 consists of the following parts, under the general title Methods for the calibration of vibration and shock pick-ups: —PartO:Basicconcepts Part 1:Primary vibration calibration by laser interferometry -- Part 2: Primary shock calibration by light cutting -Part 3: Secondary vibration calibration - Part 4: Secondary shock calibration Part 5:Calibration by Earth'sgravitation --- Part 6:Primary vibration calibration at low frequencies - Part 7: Primary calibration by centrifuge - Part 8: Primary calibration by dual centrifuge ISO1993 Ali rights reserved. No part of this publication may be reproduced or utilized in any form or mission in writing from the publisher. Internationai Organization for Standardization Case Postale 56 · CH-1211 Geneve 20 · Switzerland Printed in Switzerland ii Not for Resale ISO 5347-13:1993(E) Part 9: Secondary vibration calibration by comparison of phase an- gles 一 Part10:Primary calibration byhigh-impact shocks - Part 11:Testing of transverse vibration sensitivity Part 12: Testing of transverse shock sensitivity --- Part 13: Testing of base strain sensitivity Part 14: Resonance frequency testing of undamped accelerometers on a steel block --- Part 15:Testing of acoustic sensitivity Part 16: Testing of mounting torque sensitivity --Part 17:Testing of fixed temperature sensitivity -Part 18:Testing of transient temperature sensitivity -Part 19:Testing of magnetic field sensitivity Part 20:Primary vibration calibration by the reciprocity method ii Copyright Intermational Organization for Standardization ed without license from IHS Not for Resale