INTERNATIONAL STANDARD ISO 2176:1995 TECHNICAL CORRIGENDUM 1 ISO Published 2001-06-15 INTERNATIONALORGANIZATION FOR STANDARDIZATION MEKAYHAPOAHAAOPTAHM3ALIMANOCTAHIAPTИ3ALMW ：ORGANISATION INTERNATIONALEDENORMALISATION Petroleum products Lubricating grease --- Determination of dropping point TECHNICAL CORRIGENDUM 1 Produitspetroliers--Graisseslubrifiantes-Determination dupointdegoutte RECTIFICATIFTECHNIQUE1 Technical Corrigendum 1 to International Standard ISO 2176:1995 was prepared by Technical Committee ISO/TC 28, Petroleum products and lubricants. Page 4 Repiace 3.10 with the following text. 3.10 Polished metal rod, 1,2 mm to 1,6 mm in diameter and approximately 150 mm in length. ICS 75.100 Ref.No.ISO 2176:1995/Cor.1:2001(E) @ ISO 2001 - All rights reserved Provided by IHS under license with ISO No reproduction or networking permitted without license from IHS Not for Resale 4851903 0606323531 INTERNATIONAL ISO STANDARD 2176 Second edition 1995-03-15 Petroleum products Lubricating grease - Determination of dropping point Produits petroliers - Graisses lubrifiantes -.- Determination du point de goutte ISO Reference number ISO 2176:1995(E) Copyright Intemational Organization for Standardization Not for Resale E06T5h h2E9090 478 ISO 2176:1995(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing international Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard ISO 2176 was prepared by Technical Committee iSO/TC 28. Petroleum products and lubricants. This ssecond edition cancelsand replaces the first edition (ISO 2176:1972), which has been technically revised. Annex A forms an integral part of this International Standard. ISO1995 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utiized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in wrting from the pubisher. International Organization for Standardization Case Postale 56· CH-1211 Geneve 20· Switzerland Printed in Switzerland ii pyrgheainalrganzatioor Standardizatio Not for Resale