ISO INTERNATIONAL STANDARD 6392-2 Firstedition 1996-11-15 Earth-moving machinery - Lubrication fittings - Part 2: Grease-gun nozzles Engins de terrassement-Raccords de graissage - Partie 2: Buses de pistolets a graisse ISO Reference number ISO6392-2:1996(E) Organization for Standardizatior Noreproductionornetworkingpermitedwithout licensefromHS Not for Resale ISO 6392-2:1996(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non- governmental, in liaison with Iso, aiso take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees sare circuiated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard 1sO 6392-2 was prepared by Technical Committee ISO/TC 127, Earth-moving machinery, Subcommittee SC 3, Operation and maintenance. This first edition of ISO 6392-2 together with ISO 6392-1 canceis and replaces IS0 6392:1980, which has been technically revised. ISO 6392 consists of the following parts, under the general title Earth- movingmachinery-Lubricationfittings: Part 1: Nipple type Part2:Grease-gun nozzles Annexes A and B of this part of ISO 6392 are for information only. @ISO1996 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Organization for Standardization Case postale 56 . CH-1211 Geneve 20 · Switzerland Printed in Switzerland ii or Standardizatior Not for Resale ISO 6392-2:1996(E) INTERNATIONAL STANDARD ISO Earth-moving machinery Lubrication fittings - Part 2: Grease-gun nozzles IScope This part of IsO 6392 specifies grease-gun nozzles to be used for the injection of grease into the lubrication points The grease-gun nozzles covered by this part of IsO 6392 are used on the types of earth-moving machinery defined inISO6165. 2 Normative reference The following standard contains provisions which, through reference in this text, constitute provisions of this part of IsO 6392. At the time of publication, the edition indicated was valid. All standards are subject to revision, and parties to agreements based on this part of isO 6392 are encouraged to investigate the possibility of applying the most recent edition of the standard indicated below. Members of IEC and IsO maintain registers of currently valid International Standards. Iso 6165:—1), Earth-moving machinery -Basic types -- Vocabulary. 3 Nozzle type and mounting position 3.1 Nozzle type (see figure 3). The rubber nozzle-centre type is recommended for the grease-gun nozzles to be used on earth-moving machinery. leakage is lesscompared tothe steel nozzle-centretype. 3.2 Mounting position Figure 1 shows an example of the mounting position of the grease-gun nozzle. The specific type of grease gun is not prescribed. 1) To be published. (Revision of ISO 6165:1987) Copyright Intern duction or ig permitted withou license from IHS Not for Resale