ISO INTERNATIONAL STANDARD 5782-2 First edition 1997-12-15 Pneumatic fiuid power - Compressed air filters - Part 2: Test methods to determine the main characteristics to be included in supplier's literature Transmissions pneumatiques - Filtres pour air comprime- Partie 2: Methodes d'essai pour déterminer les principales caracteristiques a inclure dans la documentation des fournisseurs This material is reproduced from Iso documents under International Organization for Standardization (Iso) Copyright License number IHS/lcc/1996. Not for resale. No part of these iSo documents may be reproduced in any form, electronic retrieval system or otherwise, except as allowed in the copyright law of the country of use, or with the prior written consent of iso (Case postale 56, 1211 Geneva 20, Switzerland, Fax +41 22 7341079),IHSortheIsoLicensor'smembers. Iso Referencenumber ISO 5782-2:1997(E) ernational Organization for Standardization Not for Resale ISO 5782-2:1997(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non- governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on ail matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International a vote. International Standard IsO 5782-2 was prepared by Technical Committee ISO/TC 131, Fluid power systems, Subcommittee SC 5, Control products andcomponents. ISO 5782 consists of the following parts, under the general title Pneumatic fluid power Compressed air filters: Part 1: Main characteristics to be included in supplier's literature and product-markingrequirements Part 2: Test methods to determine the main characteristics to be included in supplier's literature Annex A of this part of ISO 5782 is for information only @ISO1997 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Organization for Standardization Case postale 56 . CH-1211 Geneve 20 · Switzerland Internet [email protected] X.400 C=ch; a=4oonet; p=iso; o=isocs; S=central Printed in Switzerland ii No reproduction or networking permitted without license from IHS Not for Resale @ISO ISO 5782-2:1997(E) Introduction In pneumatic fluid power systems, power is transmitted and controlled the air media is desired, filters are components designed to remove solid and liquid contaminants from compressed air. ili CoymainalganizatoSandardizatio No reproduction or networking permitted without license from IHS Not for Resale