ISO INTERNATIONAL STANDARD 14527-2 First edition 1999-11-15 Plastics Urea-formaldehvde and urea/melamine-formaldehyde powder moulding compounds (UF- and UF/MF-PMCs)- Part 2: Preparation of test specimens and determination of properties Plastiques Poudres a mouler a base d'urée-formaldéhyde et d'uree/melamine-formaldehyde(UF-etUF/MF-PMC) Partie 2: Préparation des éprouvettes et détermination des proprietes Reference number A ISO 14527-2:1999(E) ISO @ ISO 1999 Not for Resale ISO14527-2:1999(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is atrademarkofAdobeSystems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event @ISO1999 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ ISO 1999 - All rights reserved itted without licensefrom IHS Not for Resale ISO 14527-2:1999(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO committees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeenestablishedhas liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this part of IsO 14527 may be the subject oi patent rights. IsO shall not be held responsible for identifying any or all such patent rights. SC 12, Thermosetting materials. three parts of iSO 14528, will replace ISO 2112:1990, of which they constitute a technical revision. ISO 14527 consists of the following parts, under the general title Plastics — Urea-formaldehyde and urea/melamine-formaldehyde powder moulding compounds (UF- and UF/MF-PMCs): Part1:Designationsystemandbasisforspecifications Part 2: Preparation of test specimens and determination of properties Part3:Requirementsforselectedmoulding compounds nafonai Onganizationfor Standardizalin?Served ii