ISO INTERNATIONAL STANDARD 11928-2 First edition 2000-02-15 Micrographics Quality control of graphic COM recorders - Part 2: Quality criteria and control Micrographie -Controle de la qualité des imprimantes COM graphiques - Partie 2: Criteres et controle qualité Reference number ISO 11928-2:2000(E) ISO @ ISO 2000 py IHS under ted without license from IHS Not for Resale ISO 11928-2:2000(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISo Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event @ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ Iso 2000 - All rights reserved py IHS unde ermittedwithoutlicense from IHS Not for Resale ISO 11928-2:2000(E) Contents Page Foreword. IV Introduction 1 Scope 2 Normativereferences 3 Terms and definitions 4 Evaluation 4.1 General. 4.2 Test runs.. 4.3 System tolerances. 5 Test frames: methods of use...... 5.1 Test for frame size, linearity and positioning 5.1.1 General... 5.1.2 Methods 5.2 Test for resolution, legibility and density . 5.2.1 Resolution 5.2.2 Legibility. 5.2.3 Density. 5.3 Test for radial recording . 5.4 Test for curved lines 5.4.1 Introduction 5.4.2 Method .... 5.5 Test frame for measuring character display and rotation. Annex A (informative) Line density ili d by IHS under se from IHS Not for Resale