ISO INTERNATIONAL STANDARD 10405 Second edition 2000-03-01 Petroleum and natural gas industries Care and use of casing and tubing Industries du peétrole et du gaz naturel - Entretien et utilisation des tubes de cuvelage et de production Reference number ISO 10405:2000(E) ISo @ ISO 2000 py IHS under ted without license from IHS Not for Resale ISO 10405:2000(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event @ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ IsO 2000 - All rights reserved Not for Resale ISO 10405:2000(E) Contents Page Foreword. .iv 1 Scope 2 Normative references . 3 Termsand definitions .. 4 Running and pulling casing.. 4.1 Preparation and inspection before running. 4.2 Drifting of casing .............. 4.3 Stabbing, making up and lowering 4.4 Field makeup...... 4.5 Casing landing procedure, 4.6 Care of casing in hole .. 4.7 Recovery of casing ... 4.8 Causes of casing trouble .. 5 Running and pulling tubing .. 5.1 Preparation and inspection before running. .9 5.2 Stabbing, making up and lowering 11 5.3 Field makeup.... 5.4 Pulling tubing ... 5.5 Causes of tubing trouble 13 6 Transportation, handling and storage.. 14 6.1 Transportation... 6.2 Handling.. .15 6.3 Storage.. 16 7 Inspection and classification of used casing and tubing... 16 7.1 16 7.2 Inspection and classification procedures....... 7.3 Pipe wall and threaded-joint conditions... 17 7.4 18 Reconditioning.... 8 18 9 Field welding of attachments on casing .. 18 9.1 9.2 Requirements for welds. 19 9.3 Processes... 19 9.4 19 9.5 19 9.6 Preheating and cooling .... 19 9.7 Welding technique.... 20 Annex A (informative) Sl units 39 CopyrightInternaaganzaonfor Sandardizalionserved ii ded by IHS under license with IE ted withoutlicensefrom IHS Not for Resale