ISO INTERNATIONAL STANDARD 26430-2 First edition 2008-09-01 Digital cinema (D-cinema) operations - Part 2: Digital certificate Opérations du cinéma numérique (cinéma D) - Partie 2: Certificat numérique Reference number ISO 26430-2:2008(E) @ ISO 2008 ISO 26430-2:2008(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation COPYRIGHT PROTECTED DOCUMENT ? ISO2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @IsO2008-All rights reserved ISO 26430-2:2008(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeen non-governmental, in liaison with Iso, also take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. SMPTE 430-2-2006) and was adopted, under a special “"fast-track procedure", by Technical Committee ISO/TC 36, Cinematography, in parallel with its approval by the ISO member bodies. Iso 26430 consists of the following parts, under the general title Digital cinema (D-cinema) operations: Part1:Keydeliverymessage Part 2: Digital certificate Part 3: Generic extra-theater message format anization for Standar izalion'ghts reserved ili