ISO INTERNATIONAL STANDARD 15641 First edition 2001-09-01 Milling cutters for high speed machining Safety requirements Fraises pour usinage a grande vitesse -Prescriptions de sécurite Reference number ISO 15641:2001(E) ISO @ ISO 2001 IHS under Not for Resale ISO 15641:2001(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2001 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Casepostale56.CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland IsO2001-All rights reserved itted without license from IHS Not for Resale ISO 15641:2001(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. sO shall not be held responsible for identifying any or all such patent rights. Technical Committee TC 29, Small tools, in accordance with the Agreement on technical cooperation between ISO and CEN (Vienna Agreement). Throughout the text of this standard, read "...this European Standard..." to mean "...this International Standard...". Annexes A and B of this International Standard are for information only nafionai Organization for Standardizationserved ii