ISO INTERNATIONAL STANDARD 12576-1 First edition 2001-09-15 Thermal insulation Insulating materials and products for buildings Conformity control systems Part 1: Factory-made products Isolation thermique Matériaux et produits d'isolation pour le batiment- Systemes de controle de la conformite Partie 1: Produits fabriqués en usine Reference number ISO 12576-1:2001(E) Tso @ ISO 2001 Copyright Intemational Organization for Standardization No reproduction or networking permited without license from IHS Not for Resale ISO 12576-1:2001(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2001 tronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's mem- ber body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 4122 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland pyhatoganizatSandadizatio @ ISO 2001 - All rights reserved No reproduction or networking permitted without license from IHS Not for Resale ISO 12576-1:2001(E) Contents Page Scope Normative references 2 Terms and definitions . 4 Conformity systems, their elements and recommended application of the systems 4.1 General 4 4.2 System 1 Manufacturer's declaration of conformity without any participation of a third party 5 4.3System 2 Manufacturer's declaration of conformity, where the manufacturer's production control is certified by a third party ... 4.4System3Manufacturer'sdeclarationofconformity,wherethemanufacturer'sproductioncontroliscertified by a third party and initial type testing is done by a third party 5 4.5 System 4 Product certification by an independent approved certification body 5 4.6System 5 Lot testing of the consignment by the customer or his representative 6 5Factory production control 6 5.1 General 6 5.2 Quality manual ... 6 5.3 Nature, extent and frequency of inspections and tests 5.4 Testing 8 5.5 Indirect testing 8 5.6 Manufacturer's log 9 5.7 Persons responsible for factory production control 9 5.8 Measures in the event of non-compliance with the requirements 9 6 Certification of factory production control and of products 10 6.1 General 10 6.2Surveillance and assessment of factory production control 10 6.3 Product certification 11 6.4Measures in the case of non-compliance with the specification or other omissions 12 7 Sampling 12 8 Sample size and acceptance criteria for lot testing (System 5) 13 8.1 Sampling and sample size 13 8.2 Acceptance criteria 14 Bibliography.. 16 ionalganizationforStandardizationserved ii No reproduction or networking permited without license from IHS Not for Resale