ISO INTERNATIONAL STANDARD 12097-3 First edition 2002-06-15 Road vehicles Airbag components - Part 3: Testing of inflator assemblies Vehicules routiers - Composants des sacs gonflables - Partie 3: Essais des génerateurs de gaz Reference number ISO 12097-3:2002(E) ISO @ ISO 2002 THS under Not for Resale ISO 12097-3:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ Iso 2002 - All rights reserved itted without licensefrom IHS Not for Resale ISO 12097-3:2002(E) Contents Page Foreword. 1 Scope 2 Normative references. 3 Terms and definitions . 4 General requirements.. 5 General test conditions 5.1 Purpose of environmental testing 5.2 Test sequence.... 5.3 Measurements and test report 5.4 Test programme.. 6 Environmental testing. 6.1 General.. 5 6.2 Droptest. 6.3 Mechanical impact test . 6.4 Vacuum test ... 6.5 Simultaneous vibration and temperature test. 6.6 Thermal humidity cycling .... 12 7 Performance testing ..... 14 7.1 Electrostatic discharge (ESD) test. 14 7.2 Electromagnetic compatibility (EMC) test... 17 7.3 Tank test... 18 7.4 Bonfire test... 20 7.5 Trigger device testing .... 22 7.6 Burst test.... 22 Annex A (normative) Definition of temperature build-up time, te. 23 Annex B (informative) Survey of origin of environmental test procedures 25 Bibliography. ii Copyright Interna HS unde from IHS Not for Resal