ISO INTERNATIONAL STANDARD 11318 Secondedition 2002-08-01 Cardiac defibrillators Connector assembly DF-1 for implantable defibrillators Dimensions and test requirements Defibrillateurs cardiaquesEnsemble connecteur DF-1 pour defibrillateurs implantables -Dimensions et exigences d'essai Reference number ISO 11318:2002(E) @ ISO 2002 CyationalganzainStandardizatio No reproduction or networking permitted without license from IHS Not for Resale ISO:11318:2002(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland CyationalganzainStandardizatio @ ISO 2002 - All rights reserved No reproduction or networking permitted without license from IHS Not for Resale ISO11318:2002(E) Contents Page Scope 1 2 Normative reference 3 Terms and definitions 4 Requirements 2 Annexes A Lead connectorelectricalisolationtest.... 8 Connector cavity current-carrying test... 13 c Rationale for lead connector electrical isolation test..... 16 D Rationale for connector cavity current-carrying test... 18 E Rationale for requirements of this International Standard.. 19 CopyrghtInternatinal organization for Standagdizationuserved ili No reproduction or networking permitted without license from IHS Not for Resale