ISO INTERNATIONAL STANDARD 10893-2 First edition 2011-04-01 Non-destructive testing of steel tubes - Part 2: Automated eddy current testing of seamless and welded (except submerged arc-welded) steel tubes for the detection of imperfections Essais non destructifs des tubes en acier- Partie 2: Controle automatisé par courants de Foucault pour la detection des imperfections des tubes en acier sans soudure et soudés (sauf a I'arc immergé sous flux en poudre) Reference number ISO 10893-2:2011(E) @ ISO 2011 Not for Res: ISO 10893-2:2011(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHTPROTECTEDDOCUMENT @ISO2011 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or ISo's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ Iso 2011 - All rights reserved I without license from IHS Not for Resale ISO 10893-2:2011(E) Contents Page Foreword .iv 1 Scope 2 Normative references 3 Terms and definitions. 4 General requirements 5 Test method... 5.1 Test techniques 5.2 Test equipment. 6 Reference tube 6.1 .6 6.2 Concentric coil technique. 6.3 Segment coil technique .. 6.4 Fixed and rotating coil/pancaketechnique. 6.5 Dimensions of the reference standards 7 Equipment calibration and checking. 9 8 Acceptance 9 Test report.. AnnexA(informative)Guidancenotesonlimitationsofeddycurrenttestmethod........ Copyrght InternationalOrganizaionStandardizaonghtsreserved ii from IHS Not for Resale