说明:收录全球国际标准 提供单次或批量下载
ISO/TS TECHNICAL SPECIFICATION 19425 First edition 2015-12-15 Reciprocating internal combustion engines Measurement method for air cleaners Sound power level of combustion air inlet noise and insertion loss using sound pressure Moteurs alternatifs a combustion interne - Methode de mesure du bruit des purificateurs d'air - Niveau de puissance sonore du bruit d'entrée d'air de combustion et de perte d'insertion utilisant une pression sonore Reference number ISO/TS 19425:2015(E) ISO International Organization for Standardization @ IS0 2015 HS unde ed without license from IHS IS0/TS 19425:2015(E) COPYRIGHT PROTECTEDDOCUMENT IS0 2015, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel: +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org icensee-ZHEJIANG INSTOF STANDARDIZAoISQ 05 - All rights reserved Not for Resale, 2016/3/29 05:17:00 networking permited without license from IHS IS0/TS 19425:2015(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references 3 Terms and definitions 4 Test environment .5 4.1 General .5 4.2 Criterion for background noise. .5 4.3 Criterion for acoustic adequacy of test environment .6 5 Instrumentation. .6 5.1 General. .. 6 5.2 Calibration .6 5.3 Application .6 6 Installation and operation conditions 6.1 General 6.2 Installation condition 6.3 Operation condition.. ..8 7 Measurement ..8 7.1 General ..8 7.2 Measurement uncertainty ..9 7.3 Characteristic source dimension .10 7.4 Measurement radius .10 7.5 Measurement surface and area .10 7.6 Microphone arrays. 10 8 Calculation .12 8.1 General 12 8.2 Calculation of sound powerlevel .12 8.2.1 Mean time-averaged sound pressure levels .12 8.2.2 Corrections for background noise. ..13 8.2.3 Corrections for environmental .13 8.2.4 Surface time-averaged sound pressure levels ..14 8.2.5 Sound power levels. ..14 8.3 Calculation of insertion loss .14 9 Information to be recorded ..15 10 Test report. ..16 Annex A (normative) Qualification procedures for the acoustic environment 17 Annex B (normative) Calculation of A-weighted sound power levels from frequency band levels 20 Annex C (normative) Sound power level under reference meteorological conditions. .22 Bibliography ..24 ii icenSee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 d without license from IHS Not for Resale, 2016/3/29 05:17:00

.pdf文档 ISO TS 19425 2015 Reciprocating internal combustion engines — Measurement method for air cleaners — Sound power level of combustion air inlet noise and insertion loss using sound pressure

文档预览
中文文档 32 页 50 下载 1000 浏览 0 评论 309 收藏 3.0分
温馨提示:本文档共32页,可预览 3 页,如浏览全部内容或当前文档出现乱码,可开通会员下载原始文档
ISO TS 19425 2015 Reciprocating internal combustion engines — Measurement method for air cleaners — Sound power level of combustion air inlet noise and insertion loss using sound pressure 第 1 页 ISO TS 19425 2015 Reciprocating internal combustion engines — Measurement method for air cleaners — Sound power level of combustion air inlet noise and insertion loss using sound pressure 第 2 页 ISO TS 19425 2015 Reciprocating internal combustion engines — Measurement method for air cleaners — Sound power level of combustion air inlet noise and insertion loss using sound pressure 第 3 页
下载文档到电脑,方便使用
本文档由 人生无常 于 2024-08-26 09:26:42上传分享
友情链接
站内资源均来自网友分享或网络收集整理,若无意中侵犯到您的权利,敬请联系我们微信(点击查看客服),我们将及时删除相关资源。