ISO/TS TECHNICAL SPECIFICATION 17242 First edition 2014-05-01 Quasi-static calibration procedure for belt force transducers Procedure d'etalonnage quasi-statique pour capteurs d'efforts pour ceintures Reference number IS0/TS17242:2014(E) LSO IS02014 IHS under Noreproo itted without license from IHS Not for Resale IS0/TS 17242:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ ISO 2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyrightoffice Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0/TS 17242:2014(E) Contents Page Foreword ..iv 1 Scope 2 Normative references 3 General specifications. 3.1 General 2 3.2 Limitations or the application of the test belt strap 2 4 Test conditions. .3 4.1 Test method 3 4.2 Clamping length .3 4.3 Test velocity 3 4.4 Belt strap. .3 4.5 Load relieving .3 4.6 Data acquisition 3 4.7 Data evaluation. .3 4.8 Sensor excitation .4 4.9 Environmental conditions ..4 5 Calibration procedure 5.1 Conditioning .4 5.2 Test preparation 5.3 Calibration test. .4 5.4 Data storage 5.5 Data evaluation. 4 5.6 Documentation ..5 Annex A (normative) Test setup .6 Annex B (normative) Evaluation method Annex C (informative) Belt strap characteristics ..10 Annex D (informative) Applications notes ..12 iii ded by IHS under license with IS withoutlicense from IHS Not for Resale