ISO/TS TECHNICAL SPECIFICATION 13399-80 Second edition 2017-05 Cutting tool data representation and exchange - Part 80: Creation and exchange of 3D models - Overview and principles Repreésentation et échange des données relatives aux outils coupants Partie 80: Création et échange de modeles 3D - Vue d'ensemble et principes Reference number IS0/TS13399-80:2017(E) [so International Organization for Standardization HEJIANG INST OF STANDARDIZATION C1 5956617 @ IS0 2017 ed without license from IHS IS0/TS 13399-80:2017(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2017, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. IsOcopyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Intenationaibr PrganizationforStandardization icensee-ZHEJIANG INST OF STANDARDIZRoISQ s1.7 - All rights reserved Not for Resale, 2017/8/21 02:10:35 etworking permitted without license from IHS IS0/TS 13399-80:2017(E) Contents Page Foreword ..iv Introduction. .. 1 Scope 2 Normative references 3 Terms and definitions 4 Abbreviated terms ..2 5 Designation of design elements .3 5.1 General. .3 5.2 Reference system .3 5.2.1 Primary coordinate system"PCs" .3 5.2.2 Coordinate system workpiece side“CSW" ..4 5.3 Planes. .6 5.3.1 Primary planes .6 5.3.2 Planes at workpiece side .6 5.4 Axes. .6 5.4.1 Primaryaxes .6 5.4.2 Axes at workpiece side .6 5.5 Solid design elements .6 5.6 Level of detail. .6 5.6.1 General 5.6.2 Basic model. 5.6.3 Detailed model. 7 6 Colour setting. .7 6.1 Colour setting for the model .7 6.2 Colour setting for the cutting edge line and the cutting part line 6.3 Colour setting overview. ..8 7 3D model data exchange. ..8 7.1 General. 7.2 Data exchange model structure. ..8 7.3 Indexable inserttools table ..9 7.3.1 STP Basic and detail format 9 7.3.2 Detail STP structure. .11 7.3.3 Basic STP structure. .16 7.4 Non-indexable tools table 21 7.4.1 STP basic and detail format 21 7.4.2 Detail STP structure. .22 7.4.3 Basic STP structure.. 24 7.5 Cutting item table 25 7.5.1 STP basic and detail format .25 7.5.2 Detail STP structure.. 26 7.5.3 Basic STP structure. 28 7.6 Adaptive item table 29 7.6.1 STP basic and detail format 29 7.6.2 Detail STP structure. 30 7.6.3 Basic STP structure. .32 Bibliography .34 iii See=ZHEJIANG INSTOFSTANDARDIZATION C15956617 ed without license from IHS