ISO/TS TECHNICAL SPECIFICATION 13399-71 First edition 2016-07-15 Cutting tool data representation and exchange - Part 71: Graphical data layout Creation of documents for standardized data exchange: Graphical product information Représentation et échange des données relatives aux outils coupants- Partie 71: Format des données graphiques - Création de documents pour I'echange de données normalisées: Informations graphiques des produits Reference number IS0/TS13399-71:2016(E) ISO International Organization for Standardization @ IS0 2016 HEJIANG INST OF STANDARDIZATION C1 5956617 ed without license from IHS IS0/TS 13399-71:2016(E) COPYRIGHT PROTECTEDDOCUMENT IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Licensee-ZHEJIANG INST OF STANDARDIZAISQ 0d6 - All rights reserved Not for Resale, 2016/9/22 06:57:42 networking permited without license from IHS IS0/TS 13399-71:2016(E) Contents Page Foreword ..iv Introduction. ...vi 1 Scope. 2 Normative references 3 Fundamental system description. .2 4 Definition of the drawing elements .2 4.1 Drawing frame .2 4.2 Graphic of the cutting tool .3 4.3 Manufacturer/supplier block. .3 4.4 Data table. ..3 4.5 Mapping list 3 5 Structure and layout of the drawing elements .3 5.1 Drawing frame. .3 5.2 Tool graphic 3 5.3 Manufacturer/supplier block 5.3.1 General. .4 5.3.2 Data content and size of the fields ..4 5.3.3 Design of the manufacturer block .4 5.4 Data table for drawing header and bill of material .5 5.5 Internal mapping list .5 Functional description .5 6.1 General .5 6.2 Workflow for standard tools. 6.3 Workflow for custom solution tools .6 Bibliography .8 iii icensee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 vided by IHS under I se with ISt without license from IHS