ISO/TR TECHNICAL REPORT 16730-2 First edition 2013-07-01 Fire safety engineering Assessment, verification and validation of calculation methods - Part 2: Example of a fire zone model Ingenierie de la sécurité incendie - Evaluation, verification et validation des méthodes de calcul - Partie 2: Exemple d'un modele de zone Reference number IS0/TR16730-2:2013(E) LSO @ IS0 2013 I without license from IHS Not for Resale IS0/TR 16730-2:2013(E) COPYRIGHTPROTECTEDDOCUMENT ISO2013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax +41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2013 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0/TR 16730-2:2013(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 General information on the zone model considered 3 Methodology used in this Technical Report. .2 Annex A (informative) Description of the calculation method 3 Annex B (informative) Complete description of the assessment (verification and validation) of the caiculation method 9 Annex C (informative) Worked example .11 Annex D (informative) User's manual .21 Bibliography .22 iii se with I lout license from IHS Not for Resale