ISO/IEC INTERNATIONAL STANDARD 24770-62 First edition 2015-10-01 Information technology Real- time locating system (RTLS) device performance test methods - Part 62: High rate pulse repetition frequency Ultra Wide Band (UWB) air interface Technologies de I'information - Methodes d'essai des performances du dispositif des systemes de localisation en temps réel (RTLS) Partie 62: Méthodologie de test de interface aérienne ultra large bande (UWB) a impulsions haute fréquence de répétition Reference number ISO/IEC 24770-62:2015(E) TEC International Organization for Standardization ardization5956617 @IS0/IEC2015 IS0/IEC24770-62:2015(E) COPYRIGHTPROTECTEDDOCUMENT ISO/IEC2015,PublishedinSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax+412274909 47 [email protected] www.iso.org Intenationai br PrganizationforStandardization I by IHS unde Not for Resale, 2015/11/30 07:24:39 etworking permitted without license from IHS IS0/IEC24770-62:2015(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references 3 Terms, definitions and abbreviated terms 3.1 Terms and definitions. .1 3.2 Abbreviated terms.. 4 General .2 4.1 Performance requirements 2 4.1.1 Preface 2 4.1.2 Location accuracy 2 4.1.3 Tag capacity. 2 4.1.4 Location latency 2 4.1.5 Tag orientation 2 4.1.6 System range and packet error rates. 2 4.2 Default conditions applicable to the test methods 3 4.2.1 Preface 3 4.2.2 Test environment 3 4.2.3 Default tolerance. .3 4.2.4 System Logging. .3 5 Performance tests for IS0/IEC 24730-62 .3 5.1 System locate performance .3 5.1.1 Preface 3 5.1.2 Test objective .3 5.1.3 Test set up. 3 5.1.4 Test procedure .4 5.1.5 Test measurements and requirements .5 5.1.6 Test report. .6 5.2 Tests for mandatory UWB tag to reader air interface .7 5.2.1 Test objective .7 5.2.2 Test set up.... 5.2.3 Test procedure 7 5.2.4 Test measurements and requirements 5.2.5 Test report. .7 5.3 Tests for optional two-way-ranging air interface. .8 5.3.1 Preface .8 5.3.2 Test objective .8 5.3.3 Test set up. ..8 5.3.4 Test procedure .8 5.3.5 Test measurements and requirements .8 6 Statistical relevance of results 9 iii see=Zhejiang Institute of Standardization 5956617 cense with ISO ed without license from IHS Not for Resale, 2015/11/30 07:24:39