ISO INTERNATIONAL STANDARD 4064-3 Fourth edition 2014-06-01 Water meters for cold potable water and hot water - Part 3: Test report format Compteurs d'eau potable froide et d'eau chaude - Partie 3: Format du rapport d'essais Reference number IS0 4064-3:2014(E) LSO IS02014 HS under ted without license from IHS Not for Resale IS0 4064-3:2014(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2014 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2014 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 4064-3:2014(E) Contents Page Foreword ..iv Introduction ..V 1 Scope. ..1 2 Normative references ..1 3 Terms, definitions, symbols, and abbreviated terms 4 Type evaluation report ..1 4.1 General .1 4.2 Information concerningthetype ..2 4.3 General information concerning the test equipment .12 4.4 Check list for water meter examinations and performance tests 13 4.5 Type evaluation tests (for all water meters) 23 4.6 Type evaluation tests (for electronic water meters and mechanical water meters with electronic components) 47 5 Initial verification report .68 5.1 General 68 5.2 Information concerning the EUT verified .68 5.3 Initial verification test report (IS0 4064-2:2014|0IML R 49-2:2013, Clause 10) 68 Annex A (normative) List of documents concerning the type (IS0 4064-1:2014|0IML R 49-1:2013, 7.2.9) .73 Annex B (normative) Listing of test equipment used in examinations and tests .74 iii se with I cense from IHS Not for Resale