ISO INTERNATIONAL STANDARD 3310-2 Fifth edition 2013-09-01 Test sieves Technical requirements and testing - Part 2: Test sieves of perforated metal plate Tamis de controle - Exigences techniques et verifications - Partie 2: Tamis de controle en toles métalliques perforées Reference number IS0 3310-2:2013(E) LSO IS02013 ed without license from IHS Not for Resale IS0 3310-2:2013(E) COPYRIGHTPROTECTEDDOCUMENT ISO2013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2013 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 3310-2:2013(E) Contents Page Foreword ..iv Introduction. 1 Scope.. 2 Normative references ..1 3 Terms and definitions 4 Designation .1 5 Perforated metal plate 5.1 Requirements. .1 5.2 Testmethods 5.3 Documentation for sieve conformity .6 6 Test sieve frames .6 7 Marking of test sieves ..7 Annex A (informative) Test sieve record card .8 Bibliography. 9 Copyrhtnteatonal Onadiza rights reserved iii d by IHS under lic se with ISt ed without license from IHS Not for Resale