FINAL INTERNATIONAL ISO/FDIS DRAFT STANDARD 30021 ISO/TC 61/SC 4 Plastics Burning behaviour - Secretariat: BSI Intermediate-scale fire-resistance Voting begins on: 2013-06-15 testing of fibre-reinforced polymer composites Voting terminates on: 2013-08-15 Plastiques-Comportement aufeu-Essais de resistance aufeua échelle intermédiaire des composites polymeres renforcés de fibres RECIPIENTS OF THIS DRAFT ARE INVITED TO SUBMIT, WITH THEIR COMMENTS, NOTIFICATION OF ANY RELEVANT PATENT RIGHTS OF WHICH THEY ARE AWARE AND TO PROVIDE SUPPORTING DOCUMENTATION. Reference number BEING ACCEPTABLE FOR INDUSTRIAL, TECHNO- LOGICAL, COMMERCIAL AND USER PURPOSES IS0/FDIS30021:2013(E) DRAFT INTERNATIONAL STANDARDS MAY ON ISO OCCASION HAVE TO BE CONSIDERED IN THE DARDS TO WHICHREFERENCE MAYBE MADEIN @IS02013 py IHS under cense from IHS Not for Resale IS0/FDIS 30021:2013(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax +4122 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2013 - All rights reserved networking permited without license from IHS Nt for Resale No reproductic IS0/FDIS 30021:2013(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references ..1 3 Terms and definitions 4 Principle .1 5 Test equipment. .2 5.1 General. .2 5.2 Specimen mounting frame .2 6 Test specimen .2 6.1 Number of specimen. 2 6.2 Dimensions. .2 6.3 Structure of specimen 2 6.4 Insulation of specimen. 2 7 Conditioning. .3 8 Application of instrumentation .3 8.1 Plate thermometer. .3 8.2 Temperature measuring points of the test specimen .3 9 Test procedures. ..4 9.1 Temperature of the test room .4 9.2 Specimen mounting 9.3 Temperature before the commencement of the test 4 9.4 Commencement of the test. ..4 9.5 Heating condition. 4 9.6 Measurement and observation .4 9.7 Termination of test. .5 9.8 Observations after the test. .5 10 Test report .5 Bibliography 7 iii ded by IHS under license with ISt withoutlicense from IHS Not for Resale