ISO INTERNATIONAL STANDARD 22034-2 Second edition 2016-04-01 Steel wire and wire products - Part 2: Tolerances on wire dimensions Fil produits de fil en acier - Partie 2: Tolerances sur les dimensions des fils Reference number IS0 22034-2:2016(E) ISO International Organization for Standardization see=ZHEJIANG INST OF STANDARDIZATION C1 5956617 @IS02016 vided by IHS under I No reproduction or networking permitted without license from IHS IS0 22034-2:2016(E) COPYRIGHT PROTECTEDDOCUMENT IS0 2016, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Licensee-ZHEJIANG INST OF STANDARDIZAISQ 0d6 - All rights reserved Not for Resale, 2016/6/2 08:52:43 networking permited without license from IHS IS0 22034-2:2016(E) Contents Page Foreword ..iv 1 Scope ..1 2 Normative references 3 Terms and definitions. 4 Wire diameter tolerances ..2 4.1 General. .2 4.2 Tolerances on diameter of uncoated and metallic-coated round steel wire 4.3 Out-of-roundness (ovality) .3 4.4 Tolerances on diameter of organic coated wire 4.4.1 General. .4 4.4.2 Extruded organic coatings. 4.4.3 Sintered organic coatings .4 5 Tolerance on cut lengths ..5 5.1 Length tolerances. ..5 5.2 Straightness tolerances .5 6 Length of wire in coil 6 nemaonalgnizatinAll rights reserved ii nSee=ZHEJIANG INST OF STANDARDIZATION C1 5956617 vided by IHS under I ed without license from IHS Not for Resale, 2016/6/2 08:52:43