ISO INTERNATIONAL STANDARD 14085-2 First edition 2015-03-01 Aerospace series Hydraulic filter elements Test methods Part 2: Conditioning Série aérospatialeEléments filtrants hydrauliques-Méthode d'essais- Partie 2: Vieillissement accelére Reference number IS014085-2:2015(E) ISO International Organization for Standardization @ IS0 2015 Institute of Standardization 5956617 vided by IHS under itted without license from IHS IS0 14085-2:2015(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2015 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland Prganizationfor Standardization Not for Resale, 2015/6/2 06:51:3 networking permitted without license from IHS IS0 14085-2:2015(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references ..1 3 Terms and definitions 4 Symbols. ..2 5 Test equipment and materials ..2 6 Accuracy of measuring instruments and test conditions 7 Summary of information required prior to testing ..4 8 Thermal conditioning test. ..4 8.1 Preliminary preparation ..4 8.2 Thermal conditioning test procedure .4 9 Cold start test. .5 9.1 Preliminary preparation. ..5 9.2 Cold start test procedure .7 10 Reporting. ..8 11 Identification statement ..8 Annex A (informative) Cold Start Test Equipment .9 Annex B (informative) Test Results Sheet ..12 Bibliography .13 iii see=Zhejiang Institute of Standardization 5956617 vided by IHS under I thout license from IHS