ISO INTERNATIONAL STANDARD 11064-1 First edition 2000-12-15 Ergonomic design of control centres Part 1: Principles for the design of control centres Conception ergonomique des centres de commande - Partie 1:Principes pour la conception des centres de commande Reference number ISO 11064-1:2000(E) ISO @ ISO 2000 THS under Not for Resale ISO 11064-1:2000(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is atrademarkofAdobeSystems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event @ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.ch Web www.iso.ch Printed in Switzerland Iso2000-All rightsreserved itted without license from IHS Not for Resale ISO 11064-1:2000(E) Contents Page Foreword. iv Introduction Scope 2 Normativereferences. 3 Terms and definitions 4 Generalconsiderationsandprinciplesofergonomicdesign.. 5 Framework for an ergonomic design process 6 Phase A: Clarification... 7 Phase B: Analysis and definition. 10 8 Phase C: Conceptual design 17 9 Phase D: Detailed design.. 10 Phase E: Operational feedback... Annex A (informative) Examples of systems . Annex B (informative) Basic requirements and constraints to be clarified in clause 6. Bibliography 30 ili IHS under Not for Resal