ISO INTERNATIONAL STANDARD 10819 Secondedition 2013-07-15 Mechanical vibration and shock Hand-arm vibration Measurement and evaluation of the vibration transmissibility of gloves at the palm of the hand Vibrations et chocs meécaniques - Vibrations main-bras - Mesurage et évaluation du facteur de transmission des vibrations par les gants a la paume de la main Reference number IS0 10819:2013(E) LSO @ IS0 2013 I without license from IHS Not for Resale IS0 10819:2013(E) COPYRIGHTPROTECTEDDOCUMENT @ IS0 2013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56:CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2013 - All rights reserved No reproductic networking permited without license from IHS Not for Resale IS0 10819:2013(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. .1 2 Normative references 3 Terms and definitions ..2 4 Symbols and abbreviations ..2 5 Measuring principle and equipment. .3 5.1 General principle and setup .3 5.2 Measuring equipment .4 5.3 Vibration excitation system .7 6 Measurement conditions and procedure .8 6.1 Measurement conditions. ..8 6.2 Vibration signal .10 6.3 Test procedure. 11 7 Evaluation of results ..13 7.1 Calculation of transmissibility ..13 7.2 Bare palm adaptor vibration transmissibility ..15 7.3 Uncorrected glove vibration transmissibility .16 7.4 Corrected glove vibration transmissibility .16 8 Calculation of statistical values .17 8.1 General .17 8.2 One-third-octave vibration transmissibility ..17 8.3 Frequency-weighted vibration transmissibility .18 9 Criteria for designating gloves as antivibration gloves ..18 9.1 General .18 9.2 Vibration transmissibility of the gloves. ..18 9.3 Construction of the gloves .19 10 Test report ..21 Annex A (informative) Examples of handles with force and acceleration measuring systems ..23 Bibliography .26 iii se with ISt thout license from IHS Not for Resale