ISO INTERNATIONAL STANDARD 10406-1 Second edition 2015-01-15 Fibre-reinforced polymer (FRP) reinforcement of concrete Test methods Part 1: FRP bars and grids Polymere renforcé par des fibres (PRF) pour I'armature du béton - Méthodes d'essai- Partie 1: Barres et grilles en PRF Reference number IS0 10406-1:2015(E) ISO @ IS0 2015 IS0 10406-1:2015(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2015 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland ii @ IS0 2015 - All rights reserved IS0 10406-1:2015(E) Contents Page Foreword ..V 1 Scope .1 2 Normative references ..1 3 Terms, definitions, and symbols 3.1 Terms and definitions .1 3.2 Symbols. 4 General provision concerning test pieces 5 Test method for cross-sectional properties ..6 5.1 Test pieces. ..6 5.2 Test method 5.3 Calculations. 7 5.4 Test report. .8 6 Test method for tensile properties. ..8 6.1 Test pieces. .8 6.2 Test equipment .9 6.3 Test method ..9 6.4 Calculations. ..9 6.5 Test report. 11 7 Test method for bond strength by pull-out testing ..13 7.1 Test pieces. .13 7.2 Testing machine and devices .15 7.3 Test method ..16 7.4 Calculations. ..17 7.5 Test report. ..17 8 Test method for performance of anchorages and couplers ..18 8.1 Test method for performance of anchorages. 8.2 Test method for performance of couplers. ..19 8.3 Test report. ..19 9 Test method for long-term relaxation .20 9.1 Test pieces. 20 9.2 Testing frame and devices 21 9.3 Test temperature. .21 9.4 Test method 22 9.5 Calculations. 22 9.6 Test report. 23 10 Test method for tensile fatigue .23 10.1 Testpieces 23 10.2 Testing machine and devices 23 10.3 Test temperature. 24 10.4 Test method. 24 10.5 Calculations. 25 10.6 Test report. .25 11 Test method for alkali resistance. .25 11.1 Testpieces 25 11.2 Immersion in alkaline solution .26 11.3 External appearance and mass change .26 11.4 Tensiletest 27 11.5 Calculations .27 11.6 Test report. ..28 12 Test method for creep failure .29 @ IS0 2015 - All rights reserved ii