ISO/IEC TECHNICAL REPORT TR 24766 First edition 2009-12-15 Information technology Systems and software engineering Guide for requirements engineering tool capabilities Technologies de I'information - Ingenierie des systemes et du logiciel— Guide pour les capacités d'outil d'ingenierie des exigences Reference number ISO/IEC TR 24766:2009(E) IEC ISO @ISO/IEC2009 y IHS under ted without license from IHS Not for Resale ISO/IEC TR 24766:2009(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHTPROTECTEDDOCUMENT ISO/IEC2009 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, isO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ ISO/IEC 2009 - All rights reserved I without license from IHS Not for Resale ISO/IEC TR 24766:2009(E) Contents Page Foreword Introduction 1 Scope 2 Normative references. 3 Terms and definitions. 4 Requirements engineering process 4.1 Overview... 5 Requirements engineering tool capabilities. 5.1 Overview........ 5.2 Requirements elicitation.... 5.3 Requirements analysis . 5.4 Requirements specification . 5.5 Requirements verification and validation . .9 5.6 Requirements management 12 5.7 Other tool capabilities.. 13 6 Quality characteristics of requirements. .14 6.1 Overview... 14 6.2 Quality characteristics of requirements artifacts 6.3 Tool capabilities for quality characteristics .. .15 Annex A (informative) Requirements quality characteristics and software quality characteristics....21 Bibliography... CopyrightInternatinal Oorganizain for standardizalion All rights reserved ii nse from IHS Not for Resale