ISO INTERNATIONAL STANDARD 9117-1 First edition 2009-05-15 Paints and varnishes Drying tests Part 1: Determination of through-dry state and through-dry time Peintures et vernis - Essais de séchage - Partie 1: Détermination du séchage a cceur et du temps de séchage a coeur Reference number ISO 9117-1:2009(E) SO @ ISO 2009 al Organization for Standardizatio rovided by IHS under license with ISC ISO 9117-1:2009(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation COPYRiGHT PROTECTED DOCUMENT ? ISO 2009 electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland IsO2009-All rights reserved Provided by IHS under license with IS Licensee=Hong Kong Polytechnic Univ/9976803100 ISO 9117-1:2009(E) Contents Page Foreword. iv 1 Scope. 2 Normative references. 3 Terms, definitions and abbreviated terms... 4 Principle.. 5 Apparatus and materials. 6 Sampling... 7 Test panels.. 7.1 Substrate .... 7.2 Preparation and coating.. 8 Procedure. 8.1 Preparation of apparatus.. 8.2 Drying the test panel .... 8.3 Determination of through-dry state .... 8.4 Determination of through-dry time .... 8.5 Thickness of coating.... 9 Precision. 10 Test report. Bibliography Intemational orQiaruAllrightsreserved ili Provided by IHS under license with ISO Licensee=Hong Kong Polyte Univ/9976803100
ISO 9117-1 2009 Paints and varnishes — Drying tests — Part 1 Determination of through-dry state and through-dry time