ISO INTERNATIONAL STANDARD 7689 Second edition 2008-10-01 Aerospace Bolts, with MJ threads, made of alloy steel, strength class 1 10o MPa — Procurement specification Aéronautique et espace - Vis a filetages MJ, en acier allie, de classe de résistance 1 100 MPa - Spécification d'approvisionnement Reference number ISO 7689:2008(E) @ ISO 2008 yIHS under Not for Resale ISO 7689:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHTPROTECTED DOCUMENT @ ISO2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's memberbody in the country of the requester. ISO copyright office Case postale 56. CH-1211Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ ISo 2008 - All rights reserved I without license from IHS Not for Resale ISO 7689:2008(E) Contents Page Foreword. iv 1 Scope 2 Normative references 3 Terms and definitions.. 4 Quality assurance . 4.1 General. 4.2 Qualification inspection conditions. 4.3 Acceptance inspection conditions .... 4.4 Use of "Statistical process control (SPC)" 5 Requirements ... 5 AnnexA(informative)Crosssectionalareasandformulaefortensileloads 19 Annex B (informative) Cross section areas and formulae for double shear loads . Copyrght International Organizaionfrstandardizalonghtsreserved ii IHSunder from IHS Not for Resale