ISO INTERNATIONAL STANDARD 4395 Second edition 2009-10-15 Fluid power systems and components Cylinder piston rod end types and dimensions Transmissions hydrauliques et pneumatiques Dimensions et types des extrémités des tiges de pistons pour vérins Reference number ISO 4395:2009(E) @ ISO 2009 ISO 4395:2009(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHTPROTECTEDDOCUMENT ISO2009 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, isO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland ii @ Iso 2009 - All rights reserved ISO 4395:2009(E) Contents Page Foreword i Introduction 1 Scope. 2 Normative references.. Terms and definitions . 4 Types and dimensions for hydraulic cylinder piston rod ends.... 5 Types and dimensions for pneumatic cylinder piston rod ends.. 6 Identificationstatement(referencetothis International Standard).. Bibliography... Iso 2009-All rights reserved ii