ISO INTERNATIONAL STANDARD 3525 Secondedition 2008-07-15 Oil of amyris (Amyris balsamifera L.) Huile essentielle d'amyris (Amyris balsamifera L.) Reference number ISO3525:2008(E) @ISO 2008 ded by IHS under lic se with ISC Not for Resale ISO3525:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated Details of the software products used to create this PDF file can be found in the General nfo relative to the file; the PDF-creation COPYRIGHTPROTECTED DOCUMENT ISO2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 4122 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ISO2008-All rights reserved No reproductic Not for Resale ISO 3525:2008(E) Foreword ISO (the InternationalOrganizationforStandardization)isa worldwidefederationof nationalstandardsbodies technical committees. Each member body interested in a subject for which a technical committee has been International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in theISO/lEC Directives, Part2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. This second edition cancels and replaces the first edition (IsO 3525:1979), which has been technically revised. ii Not forResale