ISO INTERNATIONAL STANDARD 29769 First edition 2008-11-01 Thermal insulating products for building applications Determination of behaviour under point load Produits isolants thermiques destinés aux applications du batiment - Détermination du comportement sous charge ponctuelle Reference number ISO 29769:2008(E) @ ISO 2008 or Standardization with ISC No reproduction or networking pemitted without license from IHS Not for Resale ISO 29769:2008(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. AdobeisatrademarkofAdobeSystemsIncorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHT PROTECTED DOCUMENT ISO2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either Iso at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland CoDvriaht In @ IS0 2008 - All rights reserved vith ISC No reproduction or networking pemitted without license from IHS Not for Resale ISO 29769:2008(E) Contents Page Foreword. iv Introduction 1 Scope 2 Normative references .. 3 Terms and definitions... 4 Principle.. 5 Apparatus 6 Test specimens .. 4 7 Procedure. 5 8 Calculation and expressionof results.. 6 6 Accuracy of measurement. 10 Test report Annex A (normative) Modifications to the general test method for cellular glass products .. ndardization' ghts reserved ii with ISC No reproduction or networking permitted without license from IHS Not for Resale