ISO INTERNATIONAL STANDARD 26622-2 First edition 2008-11-15 Modular taper interface with ball track system - Part 2: Dimensions and designation of receivers Interfaces a cone modulaire avec systeme de serrage a billes- Partie 2: Dimensions et désignation des nez de broche Reference number ISO 26622-2:2008(E) @ ISO 2008 ISO 26622-2:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHTPROTECTEDDOCUMENT ?ISO2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland ii @ ISO 2008 - All rights reserved ISO 26622-2:2008(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with isO, also take part in the work. isO collaborates closely /with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. ISO 26622-2 was prepared by Technical Committee ISO/TC 29, Small tools. ISO 26622 consists of the following parts, under the general title Modular taper interface with ball track system: Part 1: Dimensions and designation of shanks Part 2: Dimensions and designation of receivers @ ISO 2008 - All rights reserved ili