ISO INTERNATIONAL STANDARD 26382 First edition 2010-02-15 Cogeneration systems Technical declarations for planning, evaluation and procurement Systemes de cogénération Déclarations techniques pour la planification, I'évaluation et I'acquisition Reference number ISO 26382:2010(E) @ ISO 2010 by IHS under lic Not for Resale ISO 26382:2010(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHT PROTECTED DOCUMENT @ISO2010 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, isO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ ISO 2010 - All rights reserved py IHS unde I without license from IHS Not for Resale ISO 26382:2010(E) Contents Page Foreword .iv 1 Scope 2 Normative references 3 Terms and definitions 4 Key project information and analysis for evaluation. 4.1 General 4.2 Site conditions and energy demands 4.3 Related policies and regulations 4.4 CGS planning ... 4.5 System's operational simulation 4.6 Pianning of comparison with a target comparable to the CGS 5 CGS evaluation, 5.1 Economic evaluation.. 9 5.2 Energy saving evaluation, 5.3 Environmental evaluation. 5.4 Availability and reliability evaluation 11 5.5 Total evaluation... 5.6 Evaluation procedure.. 6 Primary information and works for CGS procurement. 13 6.1 Inquiry phase. 13 6.2 Formal procurement... Annex A (informative) Typical evaluation procedure for CGS planning ... Annex B (informative) Typical life-cycle cost analysis . Annex C (informative) Typical cGS diagram and flowcharts Annex D (informative) Calculation method for the period of time during which the CGS and the conventional system have equal expenditures... AnnexE(informative)Calculationmethodfortotalprofitduringtheplantlifetime .23 Annex F (informative) Job classification related to information and works for CGs procurement......24 Bibliography 26 Copyrght International OrganizaionStadardizalonghts reserved ii nse from IHS Not for Resale