ISO INTERNATIONAL STANDARD 1920-9 First edition 2009-04-01 Testing of concrete - Part 9: Determination of creep of concrete cylinders in compression Essais dubéton- Partie 9: Determination du fluage de cylindres de béton en compression Reference number ISO 1920-9:2009(E) @ISO2009 ISO 1920-9:2009(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF fle can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHTPROTECTEDDOCUMENT @ISO2009 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii @ ISO 2009 - All rights reserved ISO 1920-9:2009(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through ISO non-governmental, in liaison with isO, also take part in the work. sO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 1920-9 was prepared by Technical Committee ISO/Tc 71, Concrete, reinforced concrete and pre- stressed concrete, Subcommittee SC 1, Test methods for concrete. Iso 1920 consists of the following parts, under the general title Testing of concrete: Part 1: Sampling of fresh concrete Part 2:Properties of fresh concrete Part 3: Making and curing test specimens Part 4: Strength of hardened concrete Part 5: Properties of hardened concrete other than strength Part 6: Sampling, preparing and testing of concrete cores Part 7: Non-destructive tests on hardened concrete Part 8: Determination of drying shrinkage of concrete for samples prepared in the field or in the laboratory Part 9: Determination of creep of concrete cylinders in compression The following part is under preparation: Part 10:Determination of static modulus of elasticity in compression @ ISO 2009 - All rights reserved ili