ISO INTERNATIONAL STANDARD 10263-6 Second edition 2009-02-01 Earth-moving machinery Operator enclosure environment - Part 6: Determination of effect of solar heating Engins de terrassementEnvironnement de I'enceinte de 'opérateur- Partie 6: Détermination de I'effet du chauffage solaire Reference number ISO 10263-6:2009(E) @ ISO 2009 IHS under Not for Resale ISO 10263-6:2009(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHT PROTECTED DOCUMENT ISO2009 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's memberbody in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2009 - All rights reserved d without license from IHS Not for Resale ISO10263-6:2009(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeer established has the right to be represented on that committee. International organizations, governmental and International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 10263-6 was prepared by Technical Committee ISO/TC 127, Earth-moving machinery, Subcommittee Sc 2, Safety, ergonomics and general requirements. revised. enclosureenvironment: Part 1: Terms and definitions Part 2: Air filter element test method Part 3: Pressurization test method Part 4: Heating, ventilating and air conditioning (HVAC) test method and performance -Part 5: Windscreen defrosting system test method Part 6: Determination of effect of solar heating nalorganzainsadadizallnghtsreserved ili