ISO INTERNATIONAL STANDARD 10069-1 Second edition 2008-08-15 Tools for pressing Elastomer pressure springs Part 1: General specification OutillagedepresseRessortsde compression en élastomere- Partie 1: Spécifications génerales Reference number ISO 10069-1:2008(E) @ ISO 2008 IHS under Not for Resale ISO 10069-1:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHTPROTECTED DOCUMENT @ ISO2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's memberbody in the country of the requester. ISO copyright office Case postale 56. CH-1211Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISo 2008 - All rights reserved I without license from IHS Not for Resale ISO 10069-1:2008(E) Contents Page Foreword. iv 1 Scope 1 2 Normative references 3 Dimensions. 2 4 Materials and their hardness 5 Designation 6 Marking. Annex A (informative) Examples of suitable applications Bibliography ... Copyright International Organizaion for standardizalon ghts reserved ii IHSunder se from IHS Not for Resale