ISO/TS TECHNICAL SPECIFICATION 26873 First edition 2010-08-15 Plastics pipes and fittings Definition and construction procedures for reference lines Tubes et accessoires en plastiques s-Définition et procédure de construction des lignes de référence Reference number ISO/TS 26873:2010(E) @ISO 2010 ISO/TS 26873:2010(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHTPROTECTEDDOCUMENT ISO2010 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, isO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland ii @ Iso 2010 - All rights reserved ISO/TS26873:2010(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been non-governmental, in liaison with isO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. In other circumstances, particularly when there is an urgent market requirement for such documents, technical committee may decide to publish other types of document: an ISO Publicly Available Specification (ISO/PAS) represents an agreement between technical experts in an isO working group and is accepted for publication if it is approved by more than 50 % of the members of the parent committee casting a vote; committee and is accepted for publication if it is approved by 2/3 of the members of the committee casting a vote. further three years, revised to become an International Standard, or withdrawn. If the ISO/PAS or ISO/TS is International Standard or be withdrawn. rights.IsOshallnotbeheldresponsibleforidentifyinganyorallsuchpatentrights ISO/TS 26873 was prepared by Technical Committee ISO/TC 138, Plastics pipes, fittings and valves for the transport of fluids, Subcommittee Sc 5, General properties of pipes, fittings and valves of plastic materials and their accessories Test methods and basic specifications. @ ISO 2010 - All rights reserved ili